dS2824
dS2824 User Manual v4.12
Event Notifications
Event notifications will send a tcp/ip message to a remote computer when selected Inputs or
Relays change state.
Event triggers are boolean expressions. They may be a single or multiple I/O.
R1 will send a notification when Relay 1 becomes active.
{R1} will send a notification when Relay 1 changes state (to active or inactive).
Enclosing the boolean expression in curly braces {} will return true when the I/O changes
state. To use multiple I/O, separate them with an | (or).
{D1|R2} will trigger a notification when either D1 or R2 changes state.
Target IP is the IP address of the computer you wish to send the message to.
Target Port is the tcp/ip port the computer is listening on.
Timeout is the time the board waits for a return message. This return message is used only as
an ACK to terminate the connection, and may be a single byte.
TimeStamp, when checked, will include the time and date in the message.
Copyright © 2016-2021, Devantech Ltd.
All rights reserved.
www.robot-electronics.co.uk
40
To Next Page
Loading...