14
A-DV56
EN
ADVAnceD menu controls
Display Example
Mode
Description
EPAP
5.0 cmH2O r 5.0
All
Bilevel
Modes
This is a prescription setting which controls the
pressure during exhale, this also shows the
pressure delta (5.0 in example) between inhale and
exhale pressure settings
Delay Time
45 minutes
All
Selectable delay time setting. Your provider has set
the delay time. If the unlocked symbol is shown,
you are able to adjust this setting. If the locked
symbol is shown, this setting can only be adjusted
by your provider.
Delay Pressure
5.0 cmH2O
CPAP
Mode
This is a prescription setting which controls the
operating pressure during the delay time.
IPAP Rounding
0 (1234 ms)
All
Bilevel
Modes
This is a setting which controls the comfort
rounding when switching to IPAP pressure, settings
are 0 thru 5 also shows measured rise time of the
last breath in milliseconds.
EPAP Rounding
0 (1234 ms)
All
Bilevel
Modes
This is a setting which controls the comfort
rounding when switching to EPAP pressure,
settings are 0 thru 5 also shows measured rise time
of the last breath in milliseconds.
Insp. Trigger
5
Bilevel
S & ST
Modes
This is a setting which controls the sensitivity of the
inspiratory trigger, can be set from 1 to 10, 1 is
most sensitive, 10 is least sensitive.
Exp. Trigger
5
Bilevel
S & ST
Modes
This is a setting which controls the sensitivity of the
expiratory trigger, can be set from 1 to 10, 1 is
most sensitive, 10 is least sensitive.
Backup Rate
15 BPM
Bilevel
ST & T
Modes
This is a setting which affects the backup pressure
cycle rate. A new breath will be triggered if the
patient’s breathing is slower than this setting.
I/E Ratio
1 : 1.0 (50%)
Bilevel
ST & T
Modes
This is a setting which affects the back up pressure
cycle rate. This is the ratio of the inhale to exhale
time and is expressed as 1:X. A new exhale will be
triggered by the Bilevel if the patient’s breathing is
slower than this setting, also linked to Backup
Rate. % inhale is shown in parenthesis.
Tubing Length
1.8 m (6 ft)
All
The standard tubing length supplied with the device
is 6 feet (1.8 meters). However, you can adjust
your IntelliPAP to accommodate an air supply
tubing length of 10 feet (3.0 meters). Replacement
tubing can be obtained through your home care
provider (part numbers listed at the end of this
manual).
To Next Page
Loading...
