DS2400Q QAM Analyzer Operation Manual
DEVISER 39 DS2400Q
In Figure 3-6-1, press to enter the tilt
channels setup menu, select the channels that
you want to do tilt test as Figure 3-6-3; press
or to change the highlight line, and
then press the to select or unselect the
channel,
Here, the and button have been
defined to page up and page down.
The "√" means this channel is selected. If you
want to cancel this selection, please press
again and "√" will disappeared. The channel
No. of all channels selected will be saved and
displayed at the left blocks
To Next Page
Loading...
