DS2400Q QAM Analyzer Operation Manual
DEVISER 68 DS2400Q
4. When edit HUM test parameter, move the
cursor by or and disable or
enable the measured channels by pressing
. The analog channel marked by "√" will
be tested in HUM item of auto test procedure.
Be sure to confirm the entry by pressing
button and return to previous menu, as
figure 3-12-8.
Figure 3-12-8
5. When edit LIMIT test parameter, you can
check and modify current limit parameter,
and then save and exit. Refer to figure
3-12-9.
To Next Page
Loading...
