Initial use 26
devolo Magic 1 WiFi
2-1
3.3.2Addition – Expanding an existing
PLC network by adding another
devolo Magic 1 WiFi
2-1
Before you can use the devolo Magic 1 WiFi
2-1
in
your devolo Magic network, first you have to
connect it to your existing devolo Magic adapters
as a network. This is accomplished by using a sha-
red password.
1 Plug the devolo Magic 1 WiFi
2-1
into an
available power socket. As soon as the LED
flashes white at regular intervals of
0.5 seconds, the adapter is ready to operate
but not yet integrated into a devolo Magic
network (see Chapter 2.3.1 Reading the PLC
indicator light).
2 Within 3 minutes, press the PLC button on a
devolo Magic adapter in your existing
devolo Magic network for approximately 1 sec.
The new devolo Magic adapter pairs auto-
matically so no button needs to be pressed.
The LED of this adapter now also flashes
white.
If the LEDs light up white on both
devolo Magic adapters, the new adapter
has been successfully integrated into your existing
devolo Magic network.
For each pairing operation, only one addi-
tional adapter can be added at a time.
3.3.3Changing the network password
A network password can also be changed in the
following ways:
b Using the web interface of the devolo Magic
adapter (see Chapter 4.5 Powerline)
or
b Using devolo Cockpit or the
devolo Home Networking App. For more
information, refer to the chapter 3.4 Installa-
tion of devolo software.
3.3.4Establish a Wi-Fi connection with
the devolo Magic 1 WiFi
2-1
Establish the WiFi connection with your laptop,
tablet or smartphone by entering the previously
noted WiFi key as the network security key.
Integrating the Wi-Fi adapter into an existing
Wi-Fi network
To ensure that the devolo Magic 1 WiFi
2-1
has the
same Wi-Fi configuration as your Wi-Fi router, you
To Next Page
Loading...
Need help?
General
