Network configuration 48
devolo Magic 1 WiFi
2-1
disable the Enable PLC button or Enable WiFi
button option.
The operating buttons are enabled in the
devolo Magic 1 WiFi
2-1
factory default settings.
Under Time zone, you can select the current time
zone, e.g. Europe/Berlin. The Time server (NTP)
option lets you specify a time server. A time server
is a server on the Internet whose task consists of
providing the exact time. Most time servers are
coupled with a radio clock. Select your time zone
and time server; the devolo Magic 1 WiFi
2-1
auto-
matically switches between standard time and
summer time.
4.7.3Configuration
Saving the device configuration
To save the enabled configuration to your compu-
ter as a file, select the corresponding button in the
System Configuration Save Configuration
to File area. The system starts downloading the
current device configuration.
Restoring the device configuration
An existing configuration file can be sent to the
devolo Magic 1 WiFi
2-1
in the System Configu-
ration area and enabled there. Select a suitable file
via the Select file ... button and start the operation
by clicking the Restore button.
Factory Settings
The devolo Magic 1 WiFi
2-1
is reset to the original
factory defaults in the System Configuration
area with the Factory Reset option.
Doing so causes you to lose your personal
WiFi and PLC settings. The last-assigned
passwords for the devolo Magic 1 WiFi
2-1
are also reset.
For backup purposes, all active configuration set-
tings can be transmitted to your computer, stored
there as a file and reloaded into the
devolo Magic 1 WiFi
2-1
. This function can be use-
ful for creating a variety of configurations that will
let you quickly and easily set up the device for use
in different network environments.
Reboot device
In order to reboot the devolo Magic 1 WiFi
2-1
,
select the Reboot button in the System Confi-
guration area.
4.7.4Firmware
The firmware of the devolo Magic 1 WiFi
2-1
inclu-
des the software for operating the device. If neces-