7. Press and release the UP arrow touch pad key three times until the dryer controller display shows the
number “195”.
8. Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the programming L.E.D.
will remain on and the temperature L.E.D. will switch o. The cool down L.E.D. will illuminate and the
dryer controller display will show the number “5”.
9. Press and release the DOWN arrow touch pad key twice until the dryer controller display shows the
number “3”.
10. Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the programming L.E.D.
will remain on and the cool down L.E.D. will switch o. The dryer controller display will change to
“Prog”.
11. Press and release the STOP touch pad key. The dry time L.E.D. will remain on and the programming
L.E.D. will switch o. The dryer controller display will change to the word “LOAd”.
The dryer is now ready for the new modied dry cycle to start. This modied dry cycle 1 program will re-
main in the dryer controller memory until the default settings push button is pressed. This default settings
push button is located on the component side of the dryer controller printed circuit board at the middle
center side of each circuit board controls.
TRANSIENT VOLTAGE SURGE SUPPRESSORS
Like most electrical equipment your new machine can be damaged or have its life shortened by voltage
surges due to lightning strikes which are not covered by factory warranty. Local power distribution
problems also can be detrimental to the life of electrical components. We recommend the installation of
transient voltage surge suppressors for your new equipment. These devices may be placed at the power
supply panel for the complete installation and don’t require and individual device for each machine.
These surge protectors help to protect equipment from large spikes and also from small ongoing spikes
in the power that occur on a day to day basis. These smaller surges can shorten overall life of electrical
components of all types and cause their failure at a later date. Although they can’t protect against all
events, these protective devices have a good reputation for signicantly lengthening the useful life of
electronic components.
Electronic Components are helped to have a longer useful life when they are supplied with the clean
stable electrical power they like.
We are including the following names and links to a few suppliers of these devices for those who don’t
currenty have a source.
MANUFACTURER LINK
MCG Surge Protection mcgsurge.com
Eaton Corporation eaton.com/us/en-us
Schneider Electric se.com/us/en
Asco Power Technolgies ascopower.com/us/en
Emerson Electric Co. emerson.com/en-us
34 35
Part # 8533-108-001 10/22 Part # 8533-108-001 10/22
Electric Heated
Parts Data
To Next Page
Loading...
