DGSHAPE DWX-53DC - Page 12

Pre-
installation
check
10
Introducti
on
Important
When using a torque screwdriver with a sleeve attached, do not loosen screws or screws that are tightened to a
torque higher than the value printed on the sleeve. The sleeve may be damaged.
What's in the Box
Cleaning fabric (1)
Milling bar (4)*2
Torque driver*3
Tablet Holder Right (1)
Screw (1)
Tablet Holder Left (1)
Screw (1)
Adapter rack (1)
Cushion
(for tablet) (4)
Adapter ID label
(for option) (1)*4
Quick Access Guide (1)
Safety Instructions (1)
*1 Attach the adapter ID label (for option) to the adapter base. The adapter ID label can be used with any number.
*2 ZRB-200D, ZPB-100D, ZPB-50D and ZPB-30D (1 per)
*3 Handle (2) bit (1.5 mm, 2.5 mm, 3.0 mm) (1 each) Sleeve (0.3 N•m, 0.6 N•m) (1 each)
*4 Used when the optional adapter is purchased.