Ceramics for Dental
Cutting Process Resin
Materials for Dental
Cutting Process
Dental casting wax
Dental non-casting cobalt-chromium alloy (before sintering)
(zirconia, wax, PMMA, hybrid ridine, PEEK, CoCr synth metal, glass fiber reinforced
resin, PEKK, gypsum)
Mountable material geometry
Step Diameter 98.5 mm, Height 10±0.3
mm Body Diameter 95 mm, Height
Max 35 mm
Mountable material weight
XY:
～
3,000 mm/min
、
Z:
～
2,700 mm/min
Shank diameter: 4 mm dia., Length: 40 to 55 mm
100-240 VAC ± 10%, 50/60 Hz (Overvoltage category: Category II, IEC60664-1), 2.8 A
Operating: 70 dB (A) or less (when
not cutting) Standby: 45 dB (A) or
less
W×D×H :650 × 763 × 831 mm
Indoor use, altitude: 2000 m or less
Temperature: 5 to 40 °C, Humidity: 35 to 80% (non-
condensing) Environmental Pollution Degree: 2
(depending on IEC60664-1)
Short-term short-term overvoltage: 1440 V, Long-term short-term overvoltage: 490 V
Power Cord, Power Plug Adapter, USB Cable, Safety Precautions, Quick Access Guide,
Detection Pin, Automatic Correction Tool, Torque Driver, T-Type Six Sumi Screwdriver, L-
Type Six Sumi Wrench, Collet Mounting and Dismounting Jig, Milling Bar Holder, Milling
Bar Positioning Jig, Regulator, Bar Code Label, Standard Adapter, Open Edge Adapter,
Adapter Rack, Adapter for Pin Material, Milling Bar, Tablet Holder, etc.
*1 Depending on the specifications and physical properties, some of the listed materials may not be machinable. For more information, contact your dealer or
our call center.
To Next Page
Loading...
