Why is the ionizer ineffective on my DGSHAPE Dental equipment?
The ionizer on your DGSHAPE dental equipment is only effective with PMMA and won't work on zirconia or wax. Clean the area with a dust collector if milling waste is present, as this decreases the ionizer's effectiveness. Ensure the unit is grounded with the ground wire for proper function.
Why does the adapter rattle on DGSHAPE DWX-52D?
If the adapter rattles on your DGSHAPE dental equipment, follow the instructions to reattach it.
What to do if milling bur management information was lost on DGSHAPE DWX-52D Dental equipment?
Milling bur information is saved per machine name. Before changing the machine name, record the milling bur information separately. Recover the information by reverting the machine name to its original name.
Why the spindle does not rotate on DGSHAPE DWX-52D?
If the spindle isn't rotating on your DGSHAPE dental equipment, check inside the maintenance cover. If the spindle belt is damaged, replace it.
Why does the computer shut down when connecting multiple DGSHAPE Dental equipment?
If your computer shuts down when connecting multiple DGSHAPE machines, turn off the power to all connected machines and disconnect the USB cables. Restart the computer and start VPanel. If VPanel won't start, reinstall it. Then, configure the settings to ensure no machines share the same ID.
Why is the cleaning tool not effective on DGSHAPE DWX-52D?
The cleaning tool on your DGSHAPE dental equipment is effective for zirconia, composite resin, and CoCr sintered metal. Ensure the holder is installed correctly, as the position differs from milling bur installation. Replace the cleaning tool if the bristles spread out. Check the milling bur holder position on the detection pin and perform automatic correction.
Why the dimensions of milling results do not match with DGSHAPE DWX-52D?
If the dimensions of your milling results don't match with your DGSHAPE dental equipment, check the CAM settings. Also, verify that the sintering program settings match the manufacturer’s workpiece being used.
What to do if the operation button does not respond on DGSHAPE DWX-52D?
If the operation button on your DGSHAPE dental equipment isn't responding, first ensure the front cover is closed, as some operations are restricted when it's open. Also, avoid wearing gloves when operating the button; use a bare hand.
Why does a hole open in the milling results of DGSHAPE DWX-52D?
If a hole appears in your milling results with DGSHAPE dental equipment, first check the CAM's milling bur settings. Also, the origin point may be out of position, so perform automatic correction, and if needed, manual correction. Finally, review the CAM milling conditions.
What to do if DGSHAPE Dental equipment is not operating even with data output?
If your DGSHAPE dental equipment isn't operating despite data being output, first ensure all covers are closed and press the operation button. Check that VPanel displays a message other than "OFFLINE", and that the correct machine is selected for output. If the PAUSE LED is lit, press the operation button to cancel the pause. Remember that milling data sent during initial operations or a data cancel will be ignored, so ensure the machine is in standby. Also, verify the milling data and check VPanel for any ERROR LED indications.
How to open, close, and view the VPanel software and its status icon on the computer.
Guides on attaching workpieces, loading burs, and initiating milling.
Important safety and handling guidelines before performing maintenance tasks.
Performing spindle warm-up and automatic machine correction for accuracy.
Addresses problems with initial operations, controls, and VPanel connectivity.
Diagnosing and fixing problems like poor surface finish, chipping, and dimensional inaccuracies.
General| Brand | DGSHAPE |
|---|---|
| Model | DWX-52D |
| Category | Dental equipment |
| Language | English |
To Next Page