DGSHAPE DWX-52D - Addressing Data Output and System Errors

Machine Trouble
68
Chapter 4 Troubleshooting
No Data Is Being Output to the Machine, or the Machine Will Not Operate Even Though Data Is Being Output
Is the front cover open?
If the front cover is open, the machine will not start mill-
ing even if milling data is being received. Close all of the
covers and press the operation button to start milling.
—
Does VPanel recognize the
machine?
Verify that a message other than "OFFLINE" is shown in
VPanel.
—
If multiple machines are connected,
is the correct machine selected?
Select the machine to output milling data to on the
VPanel screen.
—
Is operation paused?
Operation is paused if the PAUSE LED is lit. When the ma-
chine is paused, milling stops and some operations are
restricted. Pressing the operation button of the machine
will cancel the pausing of operations. Holding down the
operation button will abort milling.
—
Is initialization or a data cancel in
progress?
Milling data received during the initial operations or
during a data cancel will be cancelled. Make sure to
output milling data after conrming that the machine is
in the standby status.
—
Is the milling data correct?
Check the milling data. —
Has an error occurred?
The ERROR LED will ash if an error occurs. A description
of the error is displayed in VPanel.
P.80
The Computer Shuts Down When Connecting Multiple Machines
Are machines with the same ID
connected to the computer at the
same time?
Connecting more than one machine with the same ID to
a computer at the same time may cause the computer
to shut down. If the computer shuts down, turn o the
power of all connected machines, and then disconnect
the USB cables from the computer.
Restart the computer, and then start VPanel. If VPanel
will not start, reinstall it. After that, congure the set-
tings so that no machines are assigned the same ID.
Refer to the "Setup Guide" ("Connecting Multiple Units")
to perform the work.
—