Daily Maintenance
49
Chapter 3 Maintenance
Cleaning the Milling Bur/Adapter
Use the included cloth for care to wipe o any dirt from the portion indicated in the gure.
Part to be wiped
Care and Storage of Detection Pin and Automatic Correction Jig
For automatic correction, use the detection pin and the automatic correction jig. The presence of rust, scratches, or grime on the
detection pin or the automatic correction jig makes accurate detection impossible, which in turn may make it impossible to perform
milling as intended and may even damage the machine.
Care and Storage
• Before use, wipe the machine clean using a dry, clean cloth (which is included with the product) and make sure that the
machine is free of rust, scratches, and grime.
• Store the detection pin and the automatic correction jig in the storage compartment.
Store the automatic correction
jig with the surface shown in the
above gure visible.
To Next Page
Loading...