Starting Milling
43
Chapter 2 Milling
STEP 7: Removing the Adapter from the Machine
WARNING
Do not pull the adapter with excessive force when removing it.
Doing so may result in injury arising from your hand or arm hitting something.
Procedure
Check that milling is nished.
Open the front cover.
Turn the xing knobs (in two locations) in the directions of the arrows to release the locks.
Remove the adapter from the clamp.
Hold the adapter with both hands and pull it out slowly. Exercise caution to avoid striking the inside of the machine with
your hands or other body parts when pulling out this part.
Fixing knob
To Next Page
Loading...