47
Chapter 3 Maintenance
Maintenance Precautions
Maintenance Precautions
WARNING
Never use a pneumatic blower.
This machine is not compatible with pneumatic blowers. Milling waste may get inside the machine
and cause re or electrical shock.
WARNING
Never use a solvent such as gasoline, alcohol, or thinner to perform cleaning.
Doing so may result in re.
WARNING
Never use a vacuum cleaner to clean up milling waste.
Taking up ne cuttings using an ordinary vacuum cleaner may result in re or explosion.
WARNING
Do not touch the spindle unit or the surrounding areas immediately after milling has
ended.
Doing so may result in burns.
CAUTION
Be careful around the milling tool.
The milling tool is sharp. Broken milling tools are also dangerous. To avoid injury, exercise caution.
This machine is a precision device. Carry out daily care and maintenance.
Carefully clean away cutting waste. Operating the machine with cutting waste present may cause a malfunction.
Never install the machine in an environment where silicone substances (oil, grease, sprays, etc.) are present. Doing so may cause
poor switch contact or ionizer damage.
Never lubricate any location not specied in this manual.
To Next Page
Loading...