19
Chapter 2 Milling
Using/Reading the Built-In Panel .................................................................................... 20
Using/Reading the Built-In Panel........................................................................................................... 20
Statuses Indicated by Status Light Color ............................................................................................ 20
Switching the Power On or Off .......................................................................................21
Switching the Power On ........................................................................................................................... 21
Switching the Power O ........................................................................................................................... 21
Preparing for Milling ........................................................................................................22
CAM Settings Necessary for Milling ...................................................................................................... 22
Preparing a Workpiece (Usable Workpieces) ..................................................................................... 22
Preparing a Milling Bur (Usable Milling Burs) .................................................................................... 22
Cleaning Tool ................................................................................................................................................ 23
Compressed Air (Setting the Regulator) ............................................................................................. 23
Starting Milling ................................................................................................................24
STEP 1: Attaching a Workpiece to the Adapter ................................................................................. 24
STEP 2: Attaching the Adapter to the Machine ................................................................................ 33
STEP 3: Loading the Milling Bur ............................................................................................................. 36
STEP 4: Loading the Cleaning Tool ........................................................................................................ 38
STEP 5: Checking the Regulator Settings............................................................................................ 40
STEP 6: Outputting Milling Data and Starting Milling ................................................................... 40
STEP 7: Removing the Adapter from the Machine .......................................................................... 43
Aborting Output .......................................................................................................................................... 44
Removing Milling Data in Standby from the Output List ............................................................. 44
Automatically Switching Out the Worn Milling Bur (Intelligent Tool Control) ...................... 45
To Next Page
Loading...