Periodic Maintenance
51
Chapter 3 Maintenance
Replacing Consumable Parts
Contact your authorized DGSHAPE Corporation dealer or visit our website (http://www.dgshape.com/) to purchase items.
Part name Replacement time/Guideline
Spindle unit
When the working time of the spindle exceeds 2,000 hours (with slight
variation depending on the work situation).
You can use VPanel to view the working time of the spindle.
For information on how to perform replacement, refer to the replacement instruction manual
included with the part.
" P. 11 ""Maintenance" Tab"
* The replacement spindle unit comes with a collet and belt.
Collet
If the collet is deformed.
If an overload error or other error occurs, the collet may be deformed.
For information on how to perform replacement, refer to the replacement instruction manual
included with the part.
Spindle belt
If the spindle belt is worn.
For information on how to perform replacement, refer to the replacement instruction manual
included with the part.
Cleaning tool
If the brush bristles have spread out.
* The milling bur holder is not included with optional products.
" P. 65 "Replacing the Cleaning Tool"
To Next Page
Loading...