VPanel Window and Functions
18
Chapter 1 Operation Screen
"Cleaning" Dialog Box
Use this dialog box when you clean the machine. You can use it to perform operations such as moving the rotary axis unit and the
spindle. To verify the operation, place the mouse pointer over the button to switch the VPanel illustration.
" P. 48 "Cleaning after Milling Finishes"
Display Explanation
Dust collector ON/OFF
Turns the dust collector ON/OFF.
(For dust collectors with a linking function and connected to the expansion port with a linking
cable.)
For details on the dust collector, see the DWX-52D "Setup Guide."
Front
Moves the rotary axis unit to the front. Use this function when cleaning the rotary axis unit.
Rear
Moves the rotary axis unit to the back. Use this function when cleaning the back of the milling
area.
Reverse side
Turns the clamp over. Use this function when cleaning the back side of the clamp.
Spindle
Moves the spindle unit to a location where it is visible. Use this function when cleaning around
the spindle unit.
To Next Page
Loading...