What to do if initial operations fail on DGSHAPE DWX-52D?
If initial operations on your DGSHAPE dental equipment fail, ensure the front cover is closed during startup. The initial operations are not performed if a cover is open for safety reasons. If the milling bur is caught, detach it using the emergency release function in VPanel. Also, check the maintenance cover for any caught workpieces or milling waste.
How to fix a line of level difference in DGSHAPE Dental equipment milling results?
A line of level difference in your DGSHAPE dental equipment's milling results may be due to the origin point being out of position. Try performing automatic correction, and if that doesn't work, perform manual correction. Also, review the CAM milling conditions, as they can contribute to this issue.
Why compressed air does not come out from DGSHAPE Dental equipment?
If compressed air isn't coming out of your DGSHAPE dental equipment, remember that it's only supplied during certain operations like spindle rotation or milling bur replacement. Check the connection and ensure the pressure is set to 0.2 MPa. Also, make sure the knob at the bottom of the regulator is closed, as open knob can cause compressed air to escape.
Why does automatic correction fail on DGSHAPE Dental equipment?
If automatic correction fails on your DGSHAPE dental equipment, start by cleaning any grime from the automatic correction jig, the detection pin, and the ATC magazine. Buildup of milling waste can impede sensor operation. Also, verify that the automatic correction jig and the detection pin are properly attached, paying attention to the position of the milling bur holder on the detection pin.
What to do if VPanel does not recognize DGSHAPE DWX-52D Dental equipment?
If VPanel isn't recognizing your DGSHAPE dental equipment, first ensure all cables are properly connected, referring to the Setup Guide for assistance. Verify the connection procedure was followed correctly, as an incorrect procedure can lead to driver installation issues. Also, confirm that connections were performed correctly, referencing the Setup Guide for connecting multiple units if applicable. If the machine's ID has been changed, try restarting VPanel.
How to prevent chipping on edges of milling products with DGSHAPE Dental equipment?
To prevent chipping when using DGSHAPE dental equipment, ensure the machine is on a stable base to minimize vibration. Verify the workpiece and adapter are correctly mounted. Replace worn milling burs and review the CAM milling conditions. Also, check the CAD data to ensure the specified thickness isn't excessively thin.
Why is the milled surface of my DGSHAPE Dental equipment unattractive?
An unattractive milled surface on your DGSHAPE dental equipment could stem from several factors. Ensure the workpiece and adapter are correctly mounted to prevent loosening or misalignment during milling. A worn milling bur can also affect results, so consider replacing it, and manage its work time in VPanel. Lastly, strict milling conditions may be the cause, so review the CAM milling conditions.
How to open, close, and view the VPanel software and its status icon on the computer.
Guides on attaching workpieces, loading burs, and initiating milling.
Important safety and handling guidelines before performing maintenance tasks.
Performing spindle warm-up and automatic machine correction for accuracy.
Addresses problems with initial operations, controls, and VPanel connectivity.
Diagnosing and fixing problems like poor surface finish, chipping, and dimensional inaccuracies.
General| Brand | DGSHAPE |
|---|---|
| Model | DWX-52D |
| Category | Dental equipment |
| Language | English |
To Next Page