Bulk DFU Updates
DFU (Device Firmware Update) is the process in which you update the Firmware on your sensor. With
BLE you are able to set up a list of sensors you would like to update the firmware on (perform a DFU) and
have it run through all of them. This is useful if you are a Coach trying to update the firmware on all of
your player’s sensors. This process does not need the sensor to be assigned to a player. The only
limitation is the sensors must already have a firmware version starting with an 8 or higher (must be BLE
enabled). If the sensor is at a lower firmware version (7.6.0) then the sensor will need to be updated
through a classic connection first (Device Settings) so that it is BLE enabled.
1. Make sure the sensors you want to transfer swings from are on and ready to pair
2. Open the SENSORS page from the main menu in the app
3. Click the three dots in the top right corner
4. Select Bulk DFU
5. Select the sensors you would like to perform the update on. (Sensors that need to be updated will
have their firmware versions highlighted yellow) As you select a sensor, a green check mark appear
next to it
6. After all the sensors are selected, click DFU in the lower right corner
7. The DFU process will begin and it will connect to each sensor one at a time
8. Once the process ends, you will receive a report indicating the process is complete
9. Select Finish
Make sure to transfer any disconnected swings from the sensor before performing
the Bulk DFU. Disconnected swings that are not transferred off the sensor will be
deleted when the Bulk DFU is ran
*
Diamond Kinetics SwingTracker - 1
Page 27 of 107
To Next Page
Loading...
