OPERATOR’S MANUAL
PM300, PM332, PM400 Planter Monitors
11001-1372-201702 Rev B
20 / INSTALLATION
OPTIONAL MOUNTING 3D ADJUSTABLE BRACKET
Separate the bracket halves from one another by loosening the wing bolt.
Install the upper bracket half into the console by sliding the bracket’s
rectangular section into the console mating grooves until the snap engages.
Install the bottom bracket half at the location of your choice using locally
acquired hardware.
Figure 10
Optional 3D Mounting Bracket
The console must not obstruct the view of the operator or interfere
with the operation of the tractor.
To prevent damage to the console, be sure the snap fully engages
during installation.
Slide console
until snap
engages
Mount on vehicle
with locally acquired
hardware
Wing bolts
To Next Page
Loading...
Need help?
General
