Digi ConnectCore - Connectors and Mating Height

ConnectCore for i.MX51
©2011DigiInternational,Inc. 145
Side View
Connectors
The ConnectCore for i.MX51 module uses two Berg/FCI connectors. The following table shows
the reference number of the connectors used on the module and the reference number of
the connectors used in the development board. The mated height of the module and the
development board is 5mm.
Device Berg/FCI Connector
ConnectCore for i.MX51 module 61082-181409LF
ConnectCore for i.MX51 development board 61083-184409LF
Downloaded from Elcodis.com electronic components distributor