ConnectCore for i.MX51
©2011DigiInternational,Inc. 71
Camera Interfaces
The development board provides two camera interfaces connected to the camera sensor
interfaces of the ConnectCore for i.MX51 CPU. The I
2
C bus of the ConnectCore for i.MX51CPU
is used to configure and control the two cameras.
The I
2
C device addresses of the Digi camera application kits (CC-ACC0MT9V111) are the
following:
Interface I
2
C Address (7 bits)
Camera 1 0 x 5C
Camera 2 0 x 48
Camera 2
Connector, X17
Camera 1
Connector, X15
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
