Digi TransPort WR41 - Page 306

Configuring network interfaces Configure DialServ interfaces
Digi TransPort® Routers User Guide
306
Command Instance Parameter Values
Equivalent web
parameter
ppp n l_addr off, on
When on, allows
negotiation
When off, force
use of specified IP
address
Use a.b.c.d as the local IP
address for this router
(not negotiable)
ppp n DNSserver Valid IP address
a.b.c.d
Primary DNS server
ppp n secDNS Valid IP address
a.b.c.d
Secondary DNS server
ppp n IPmin Valid IP address
a.b.c.d
Assign remote IP
addresses from a.b.c.d to
a.b.c.d
ppp n IPrange 0-255 Assign remote IP
addresses from a.b.c.d to
a.b.c.d
ppp n transDNS Valid IP address
a.b.c.d
Primary DNS server
a.b.c.d
ppp n sectransDNS Valid IP address
a.b.c.d
Secondary DNS server
a.b.c.d
ppp n ans off, on Allow this PPP interface
to answer incoming calls
ppp n do_nat 0, 1, 2
0=Disabled
1=IP address
2=IP address and
port
Enable NAT on this
interface
IP address/IP address
and Port
ppp n natip Valid IP address
a.b.c.d
NAT Source IP address
a.b.c.d
ppp n ipsec 0=Disabled
1=Enabled
2=Enabled and
Keep SAs
Enable IPsec on this
interface/
Keep Security
Associations when this
DialServ interface is
disconnected
ppp n firewall off, on Enable the firewall on
this interface