Digi TransPort WR41 - Configure RIP Advertisements

Configuring IP routing and forwarding Configure Routing Information Protocol (RIP) settings
Digi TransPort® Routers User Guide
450
Command line
Command Instance Parameter Values Equivalent web parameter
ripauth 0-9 key Up to 16 characters Key k
ripauth 0-9 keyid 0-255 Key ID
ripauth 0-9 sday 0-31 Valid from d,m,y
ripauth 0-9 smon 0-12 Valid from d,m,y
ripauth 0-9 syear 0-65535 Valid from d,m,y
ripauth 0-9 eday 0-31 Expires d,m,y
ripauth 0-9 emon 0-12 Expires d,m,y
ripauth 0-9 eyear 0-65535 Expires d,m,y
Configure RIP advertisements
É Web
Go to
The configuration in the Interfaces > Ethernet, Interfaces > PPP, and Interfaces > GRE sub-menus
is identical. Following are the settings for Ethernet > ETH 0:
Send RIP advertisements on this interface
Check this box to enable RIP and to reveal further configuration parameters below.
Use RIP
RIP version level. Select from the values V1, V2, and V1 Compat (version 1-compatible). When RIP
version is set to V1 or V2, the router will transmit RIP version 1 or 2 packets respectively (version 2
packets are sent to the all routers multicast address 224.0.0.9). When RIP Version is set to V1