HI, MI, WI-700 service manual - 4 –servicing
4-99 Issue 9 04/2020
Signature labeller - fit printer door
Assembly ST3 printer door part number - 707-0022-A
Note: this assembly can be fitted to a L-R or R-L labeller
The instruction below shows a L-R build
Fit ball catch (MM9-00215) to catch bracket (701-0143-
A)
Use two M4x10 c/sunk screws plus M4 nut with spring
& plain washers.
Fit catch bracket to side bracket - 701-0141-B (note
position depending on L-R or R-L, lower position is
required)
Use two M5x12 pozi pan screws plus M5 nut with
spring & plain washers
Fit hinge (MM9-00124) to door (701-0139-A)
Use M5x16 pozi pan screw (2 for each hinge) plus M5
nylock nut with M5 nylon washer (F82-05) & plain
washer
To Next Page
Loading...
