HI, MI, WI-700 service manual - 8 – recommended spare parts
8-5 Issue 9 04/2020
Conveyors - HI-700
B568-734 Drive roller assembly (infeed & outfeed-non base labeller)
B568-735 Idler roller assembly (infeed & outfeed - non base labeller)
568-912 Drive roller assembly - aluminium type (scale conveyor)
578-745 Idler roller assembly - aluminium type (scale conveyor)
B568-882 Outfeed-long, drive roller for base labeller conveyor (with nylon gear)
B568-879 Outfeed-long, roller with metal drive pulley for base labeller conveyor
568-919 Outfeed-short, drive roller for base labeller conveyor (with nylon gear)
568-918 Outfeed-short idler roller for base labeller conveyor
Conveyors - HI-700W
558-046-A4 Drive roller assembly (infeed / scale)
558-047-A4 Idler roller assembly (infeed / scale)
558-048-A4 Assy drive roller (with metal pulley) - for 1st long base Labeller outfeed
558-049-A4 Assy drive roller 2 (with acetal gear) - for 1st long base labeller outfeed
558-062-A4 Drive roller assembly - for 2nd short base labeller outfeed
558-053-A4 Idler roller assembly - for 2nd short base labeller outfeed
Conveyor drive - For HI-700 & HI-700W
565-732 Conveyor timing belt
565-747 Timing belt (infeed/outfeed motor drive belt)
568-885-A4 Kit – infeed/outfeed drive assembly
565-741 Timing belt (scale motor drive belt)
MB1-00036 Bearing for scale drive shaft (2 required for assembly)
MS0-00007 Seal for scale drive shaft bearing (2 required for assembly)
MB0-00034 Plastic flange bearing (plastic bush in conveyor pulleys) – see note below
567-534-A4 Pulley assy (flanged pulley with bearings) – see note below
567-535-A4 Pulley assy (non flanged pulley with bearings) – see note below
MM8-00017 Low friction tape (used on conveyor decks)
562-469 Collar AD (tracking strip guide collar for solid belts)
ES1-00063 Limit switch (under infeed & outfeed conveyors)
Note: the parts 567-534-A4 & 567-535-A4 are an alternative to the plastic flanged bearings MB0-00034.
Only use these pulley assemblies when the conveyor already has the metal type bearings installed in
the drive pulleys in the conveyor.
To Next Page
