BAS-SVX069F-EN
17
Figure 13. Configure Tracer SC with new IP address
Physical Connections
After the Tracer BAS controller and the Digi WR21 have been configured, the next part of the
process is to physically connect them.
1. Remove the Ethernet cable end that is connected to the Tracer BAS controller and connect it
to the LAN 0 port on the Digi WR21.
2. Connect a second Ethernet cable to the LAN1 port on the Digi WR21 to the Tracer BAS
controller. Use the same port on the Tracer BAS controller that you removed the Ethernet
cable from.
EExxaammppllee: The following figures show the network before physical connection changes and after
the physical connection changes.
Figure 14. Network prior to physical connection
CCoonnffiigguurraattiioonn RReeqquuiirreemmeennttss
To Next Page
Loading...
