BAS-SVX069F-EN
25
– Configure the mask as 255.255.255.255, as shown in the following figure. (The mask is not
the same as the Tracer BAS controller network mask.)
– The IP address range must be configured with addresses that are NOT used on the Tracer
BAS controller network.
Figure 21. Modifying PPP settings
Firewall Configuration
1. In the left-hand menu, click SSeeccuurriittyy.
2. In the right-hand window, click on FFiirreewwaallll.
3. Click on the EEddiitt button next to line 4. Remove the comment symbol (#) at the beginning of
the line, then click OOKK.
4. Repeat this process for lines 5, 6, and 8. When complete, click the SSaavvee, then AAppppllyy.
Pre-shared Key and Account Creation
1. Click on SSeeccuurriittyy in the left hand menu.
2. In the right hand window, click on UUsseerrss, then UUsseerr 1100 –– 1144.
3. Under UUsseerr 1144,, enter an * (asterisk) symbol in the UUsseerrnnaammee field as shown in the following
figure.
CCuussttoommeerr RReemmoottee AAcccceessss CCoonnffiigguurraattiioonn
To Next Page
Loading...
