Digi WR21 - Configuring Trane Connect Remote Access; Test the Connectivity to the Trane Cloud

18
BAS-SVX069F-EN
Figure 15. Network after physical connection changes
Configuring Trane Connect Remote Access
Follow the instructions in the Trane Connect Remote Access How-to-Guide, BAS-SVU22 to
enable Trane Connect for your Tracer BAS controller.
Test the Connectivity to the Trane Cloud
After the Digi WR21 has been installed, it is necessary to test the Trane Connect Remote Access
connection.
1. Log into the Tracer BAS controller and navigate to IInnssttaallllaattiioonn >> IIddeennttiiffiiccaattiioonn aanndd
CCoommmmuunniiccaattiioonnss, and then select the IInntteelllliiggeenntt SSeerrvviicceess Tab.
2. Click the TTeesstt CCoonnnneeccttiioonn button to verify the Tracer BAS controller can still communicate
through Trane Connect Remote Access. See the following figure.
Access to the Tracer BAS is now possible for Trane employees through https://mybuilding.
trane.com Command Center.
Figure 16. Test connection successful
CCoonnffiigguurraattiioonn RReeqquuiirreemmeennttss