Digi XBEE2 User Manual

API operation Sending public profile commands with the API
XBee/XBee-PRO ZigBee RF Modules User Guide 148
Frame-
specific
Data
ZCL
Payload
- Load
Control
Event
Data
Issuer Event ID
26 0x78
4-byte unique identifier.
Note the 4-byte ID is sent in little endian byte
order (0x78563412).
The event ID in this example (0x12345678)
was arbitrarily selected.
27 0x56
28 0x34
29 0x12
Device Class
30 0x14
This bit encoded field represents the Device
Class associated with the Load Control
Event.
A bit value of 0x0014 enables smart
appliances and water heaters.
Note the 2-byte bit field value is sent in little
endian byte order.
31 0x00
Utility
Enrollment
Group
32 0x00
Used to identify sub-groups of devices in the
device-class. 0x00 addresses all groups.
Start Time
33 0x00
UTC timestamp representing when the
event should start. A value of 0x00000000
indicates “now”.
34 0x00
35 0x00
36 0x00
Duration in
Minutes
37 0x01
This 2-byte value must be sent in little
endian byte order.
38 0x00
Criticality
Level
39 0x04
Indicates the criticality level of the event. In
this example, the level is “voluntary”.
Cooling
Temperature
40 0xFF
Requested offset to apply to the normal
cooling set point.
A value of 0xFF indicates the temperature
offset value is not used.
Heating
Temperature
Offset
41 0xFF
Requested offset to apply to the normal
heating set point.
A value of 0xFF indicates the temperature
offset value is not used.
Cooling
Temperature
Set Point
42 0x00
Requested cooling set point in 0.01 degrees
Celsius.
A value of 0x8000 means the set point field is
not used in this event.
Note the 0x80000 is sent in little endian byte
order.
43 0x80
Frame Fields Offset Example Description

Digi XBEE2 Specifications

General

Brand	Digi
Model	XBEE2
Category	Control Unit
Language	English