Agency certifications Europe
XBee/XBee-PRO ZigBee RF Modules User Guide 190
The preceding statement must be included as a CAUTION statement in OEM product manuals in order to alert
users of FCC RF Exposure compliance.
Europe
The XBee RF Modules have been certified for use in several European countries. For a complete list, refer to
www.digi.com
If the XBee RF Modules are incorporated into a product, the manufacturer must ensure compliance of the final
product with articles 3.1a and 3.1b of the R&TTE Directive. A Declaration of Conformity must be issued for each of
these standards and kept on file as described in the R&TTE Directive. Furthermore, the manufacturer must
maintain a copy of the XBee user manual documentation and ensure the final product does not exceed the
specified power ratings, antenna specifications, and/or installation requirements as specified in the user manual.
OEM labeling requirements
The 'CE' marking must be affixed to a visible location on the OEM product.
CE labeling requirements
The CE mark shall consist of the initials “CE” taking the following form:
If the CE marking is reduced or enlarged, the proportions given in the above graduated drawing must be
respected.
The CE marking must have a height of at least 5mm except where this is not possible on account of the nature
of the apparatus.
The CE marking must be affixed visibly, legibly, and indelibly.
Restrictions
Digi does not list the entire set of standards that you must meet for each country. You assume full responsibility
to learn and meet the required guidelines for each country in your distribution market. Refer to the regulatory
agencies in those countries concerning compliance for products containing the XBee RF Module.
Power Output: When operating in Europe, XBee-PRO modules must operate at or below a transmit power output
level of 10dBm. To transmit at or below 10dBm:
Order the International variant of the XBee-PRO module, which has a maximum transmit output power of
10dBm (@ PL=4).
To Next Page
Loading...
Need help?
General
