C|24 Guide98
Transferring Controls to the
Faders Using Flip Mode
To transfer controls from the rotary encoders to
the touch-sensitive faders:
Press the Flip switch.
In Flip mode, faders can control channel pan,
Send level, Send pan, or plug-in parameters, de-
pending on the current view. See “Flip Modes”
on page 82.
To return controls to Normal mode:
Press the flashing Flip switch.
Muting C|24 Fader Movement
You can temporarily turn off C|24 faders to pre-
vent fader movement noise when monitoring a
mix.
To toggle C|24 fader movement off and on:
1 Press the Soft Keys switch.
2 Press the encoder switch that corresponds to
“Faders.”
3 Press the flashing Soft Keys switch to exit.
Mixing
Displaying Master Faders and VCA
Masters
You can temporarily focus the Master Faders or
VCA Master tracks (VCA Master tracks are avail-
able in Pro Tools HD only) in your session in the
right side of the C|24 faders.
To display Master Faders or VCA Masters:
Press the Masters switch repeatedly to cycle
display of the available track types.
Working with Automation
Setting the Automation Mode of
Channels
To cycle a channel forward through the
automation modes:
Press the Automation Mode switch on the
channel.
To cycle a channel backward through the
automation modes:
Hold the Shift (add) Modifier switch and press
the Automation Mode switch on the channel.
To toggle a channel in and out of Trim mode
(Pro Tools HD Only):
Hold the Trim switch in the Automation
Modes section and press the channel’s Select or
Auto switch.
To Next Page
Loading...
