DigiDesign C 24 - Working with Pro Tools Windows

Chapter 9: Working with C|24 89
Making Single Assignments
without Assign Mode
Instead of putting C|24 in Assign mode, you can
make single assignments from normal mode.
To assign single Inputs or Outputs:
1 Press the Input switch or Output switch in the
Assign section of the Channel Bar.
2 Press and hold the encoder switch on the track
where you want to make the assignment. The
Assign switch flashes.
3 Turn the encoder to make the assignment.
4 Press the flashing encoder switch to confirm
the assignment.
To assign single Inserts or Sends:
1 Press the Insert or Send switch in the track’s
channel strip. The Insert or Send positions are
shown in the LCD displays.
2 Do one of the following:
• For an Insert or Send position with no as-
signment, press the encoder switch that
corresponds to “assign,”
– or –
• For an Insert or Send position with a cur-
rent assignment, press and hold the en-
coder switch that corresponds to “more.”
The Assign switch flashes.
3 Turn the encoder and press the “select” and
“back” switches to make the assignment.
4 Press the flashing encoder switch to confirm
the assignment.
Working with Pro Tools
Windows
Entering Numerical Values in
Pro Tools Windows
You can enter numerical values in the on-screen
Main and Sub Counters, Start/End/Length
fields, and Pre/Post Roll fields in the Edit and
Transport windows.
To move the cursor between fields:
 Press the Previous (Left) or Next (Right) Arrow
switch to move the numerical selection back-
ward or forward through the field.
To increase or decrease the selected numerical
value:
 Press the Up or Down Arrow switch.
Displaying the Transport Window
You can show or hide portions of the Transport
window and navigate fields in the window from
C|24.
To show/hide the Transport window:
 Press the Transport switch in the Windows
section.
To show/hide the MIDI section of the Transport
window:
 Hold the Command/Ctrl Modifier switch and
press the Transport switch.
To show/hide the Counter section of the Transport
window:
 Hold the Ctrl/Win Modifier switch and press
the Transport switch.
If making an assignment in Send Console
mode, make sure the Send Pre/Post and
Send/Mute switches are not active.