DigiDesign C 24 - Page 96

C|24 Guide88
To assign a Send from Channel view:
1 Press the Send switch in the track’s channel
strip. The Send positions for the track are shown
in the LCD displays.
2 Press the Assign switch in the Assign section of
the Channel Bar.
3 Unassigned Send positions show the top level
menu for assigning Send paths: “bus” or ‘in-
terfc” (Interface).
4 Navigate the Sends menu by doing the follow-
ing:
• Turn the encoder to scroll through menu
items.
• To go down a menu level, press the encoder
switch that corresponds to “select.”
• To go up a level, press the encoder switch
that corresponds to “back.”
5 On each channel where you want to make an
assignment, turn the rotary encoder to scroll
through the list of Send paths.
6 Do one of the following:
• To confirm each assignment separately,
press the flashing encoder switch on each
channel.
• To confirm all assignments at once, press
the flashing Assign switch in the Assign
section of the Channel Bar.
• To cancel any unconfirmed assignments
and leave Assign mode, press the flashing
Escape/Cancel switch.
Assigning Inserts
To assign an Insert:
1 Press the Insert switch in the track’s channel
strip. The Insert positions for the track are
shown in the LCD displays.
2 Press the Assign switch in the Assign section of
the Channel Bar.
3 Unassigned Insert positions show the top level
menus for assigning inserts.
• On Pro Tools HD: TDM, RTAS, MMTDM
(multi-mono TDM), MMRTAS (multi-
mono RTAS), HW Ins, No Insert
• On Pro Tools LE: Plug-In, MM Plug (multi-
mono plug-in) or Insert
4 Navigate the plug-ins menu by doing the fol-
lowing:
• Turn the encoder to scroll through menu
items.
• To go down a menu level, press the encoder
switch that corresponds to “select.”
• To go up a level, press the encoder switch
that corresponds to “back.”
If plug-ins are arranged by category or manufac-
turer, these appear in subsequent levels. The fi-
nal level shows plug-in names.
5 Do one of the following:
• To confirm each assignment separately,
press the flashing encoder switch on each
channel.
• To confirm all assignments at once, press
the flashing Assign switch in the Assign
section of the Channel Bar.
• To cancel any unconfirmed assignments
and leave Assign mode, press the flashing
Escape/Cancel switch.
To remove an insert:
 While in Insert Select view, hold Default and
press the encoder switch under the Insert posi-
tion for the Insert you want to remove.