Chapter 9: Working with C|24 101
AutoMatching Controls
(Pro Tools HD Only)
To AutoMatch all currently writing controls:
1 Make sure the automation types you want to
AutoMatch are write-enabled.
2 Start playback.
3 When you reach a point in the session where
you want to return controls to their previously
written values, hold the Command/Ctrl Modi-
fier switch and press the Latch switch in the Glo-
bal Automation section.
Joining Automation Values
(Pro Tools HD Only)
To Join automation values:
1 Make sure the controls you want to join are in
a write-enabled state.
2 Stop playback during an automation pass.
3 Start playback.
4 When you want to resume automation writ-
ing at the previous values, hold the Com-
mand/Ctrl+Ctrl/Win Modifier switches and
press the Latch switch in the Global Automation
section.
Writing Automation to the Start
End, or All of a Track or Selection
(Pro Tools HD Only)
To manually write the current automation values
to the start, end, or all of a track or selection:
Press the Start, End, or All switch in the Auto
Write To section during playback.
To manually write the current automation values
back to the punch point or to the next breakpoint
in a track:
Press the Punch or Next switch in the Auto
Write To section during playback.
Writing Automation to the Start
End, or All of a Track or Selection
on Stop
(Pro Tools HD Only)
To enable/disable automatic Write to
All/Start/End/Punch/Next on Stop for a single
automation pass:
Hold the Ctrl/Win Modifier switch and press
the All, Start, End, Punch, or Next switch in the
Auto Write To section.
To latch on/turn off automatic Write to
All/Start/End/Punch/Next on Stop for all
automation passes:
Hold the Ctrl/Win+Opt/Alt (all) Modifier
switch and press the All, Start, End, Punch, or
Next switch in the Auto Write To section.
To Next Page
Loading...
