DigiDesign C 24 - Page 70

C|24 Guide62
Control Room Output Dim Function
The Dim switch applies an adjustable gain re-
duction to all Control Room monitor outputs.
The amount of Dim gain reduction can be set
while in any monitoring mode.
To set the amount of Dim gain reduction:
1 Hold the Dim switch until the switch flashes.
The Dim amount appears in the right side of the
LCD displays.
2 Turn the Control Room encoder to adjust the
Dim amount.
3 Press the flashing Dim switch to confirm the
change, or press any other switch in the Moni-
tor section to cancel the change.
Control Room Output Mono Function
The Mono switch sums the Left and Right Con-
trol Room outputs and lowers monitor output
by an adjustable amount. The amount of Mono
level reduction can be set while in any monitor-
ing mode.
To set the amount of Mono level reduction:
1 Hold the Mute switch until the switch flashes.
The Dim amount appears in the right side of the
LCD displays.
2 Turn the Control Room encoder to adjust the
Mono level reduction amount.
3 Press the flashing Mono switch to confirm the
change, or press any other switch in the Moni-
tor section to cancel the change.