C|24 Guide86
To open the Track Name/Comments dialog for a
track:
Double-press the channel’s Select switch.
To move the cursor while naming a track, do any of
the following:
Press the Previous (Left) or Next (Right) Arrow
switch to move the cursor backward or forward
through the field.
Press the Up or Down Arrow switch to move
the cursor to the beginning or end of the field.
Hold the Command/Ctrl Modifier switch and
press the Up (or Left) or Down (or Right) Arrow
switch to move to the previous or next track
name field.
Resetting Controls to Their
Default Values
To reset a channel’s track volume to 0 dB:
Press Default + the channel Select switch.
– or –
Hold Option/Alt (all) and touch the channel
fader.
To reset a channel’s pan control to 0 (center)
Press Default + the encoder switch.
To reset a send’s level to 0 dB:
Press Default + the encoder switch under
“more.” This sets the send level to 0 dB, regard-
less of the Send default setting in Pro Tools Op-
eration preferences.
To reset a channel’s mic pre gain to 0 dB:
Press Set to Default + the encoder switch un-
der the gain display.
To set a plug-in’s parameters to their default
values:
Press Default + the Compare switch.
Applying Actions to Multiple
Tracks
To apply actions to multiple tracks in a Pro Tools
Session:
1 Press the Do To All or the Do To Selected
switch.
2 Press any of the following switches to apply
the corresponding action to all tracks or all se-
lected tracks in the current session:
• Channel Mute switch
• Channel Solo switch
• Channel Solo Safe: Command/Ctrl Modi-
fier switch + Solo switch
• Global Automation Mode switches
• Channel Automation Mode switches
• Channel Select switch
• Record Enable switch
• Record Safe: Command/Ctrl Modifier
switch + Record Enable switch
• Input Monitor Mode switch
3 You can also carry out any of the following
tasks across all tracks or all selected tracks in the
session:
• Assigning Inputs, Outputs, Inserts and
Sends
• Deactivating Inputs, Outputs, Inserts,
Sends and Tracks
• Resetting controls with the Default switch
• Changing panner linkage
You can also hold Option/Alt (all) and
press the corresponding switch to reset
parameters to their default values.
To Next Page
Loading...
