23
Option Menu
The Option Menu is activated by pressing
the Menu key while in any of the
measurement Functions. The Option
Menu presents various selections that
relate to that function as described below:
The Option menu will display Hold as an
option when the measurement is in the
continuous mode, and will display
Continue as an option when the unit is in
the Hold Mode. Pressing the Menu key
while in the Option Menu will immediately
return to the current measurement
Function; a blinking "H" will appear if the
unit is in the Hold mode.
Most of the measurement Functions
require the same menu of options.
However, there are some options which do
not apply to a given measurement, in
which case the option will not appear on
the menu. Furthermore, the results of
selecting a particular option from within
various Functions may differ in terms of
navigation through the display system.
The available options for each Function
are described in Figure B on the
preceding page. The figure also shows the
results of selecting a particular option from
within each Function.
Store/Recall Menus
The Store and Recall Menus are used to
select a storage slot when either storing or
recalling a measurement data set. Except
for the display title, the Store and Recall
Menus are the same and are presented
here:
T h e t i t l e
will display either STORE or RECALL
depending on the operation. The current
timer appears in the upper right. The
screen lists all storage slots available for
that measurement Function, the number of
which depends on Function (see section
Store) The timer-stamp of the data stored
in each slot is also displayed or up to
eleven characters of the chosen label.
The currently selected slot is indicated by
the marker >. The up and down arrow
keys are used to scroll through the list of
available storage slots until the marker is
next to the desired slot, with the list of
storage slots scrolling onto the screen as
scrolling continues. Pressing the Enter key
will take you to the Label screen shown
below.
Selecting the Menu key will store the
current data to the selected slot (Store), or
recall stored data from the selected slot
(Recall). In the case of Recall, the Label
STORE 00:05:27
>1 00:04:19
2 MY BARN #1
3 PIT BY WEST
.
.
30 00:15:45
Label Slot 03
_ _ _ _ _ _ _ _ _ ...
^
Menu to Save
OPTION MENU
>Function Menu
Hold
Reset
Store
Store Graph
Recall
Print/Upload
Limping data
To Next Page
Loading...