49
Digimet Printer to be used with the Digimet 3000
The Digimet Printer unit consists of the printer and power supply. The paper roll and
printer ribbon are stored within the printer enclosure.
The printer must be connected to a power source (120 VAC) to function.
To turn the printer on – press the ON button (ON button blinks green).
To turn the printer off – press and hold the OFF button until the FEED button blinks red.
(the button blinks once, quickly)
When printing, the ON button appears solid green.
After printing, the FEED button will need to be pressed to see all that has printed.
Note: If, when initiating printing, nothing happens, do one or all of the following: 1) Make
sure there is saved data in the Digimet 2) Make sure the Digimet Printer is ON 3) Make
sure the connector at the Digimet and at the Digimet Printer are snug 4) Turn off the
Digimet Printer and the Digimet and start over.
To open the printer to change paper or to change the print ribbon, lift the top cover up.
To close, lower the top cover and press slightly forward to close completely.
Paper rolls are 2 ¼ inch (57 mm) wide and are adding machine paper rolls. If the roll is
too tight in the printer compartment it might be necessary to remove some of the paper
from the roll.
The print ribbon is an Epson HX-20 cartridge ribbon. These can be obtained from LJE
or a local stationary/computer store.
To run a printer test, turn off the printer then press the FEED button and the ON button
at the same time. When the printer stops printing the first time while running the printer
test, press the FEED button, again. The instructions to do so appear below the tear
edge of the printer.
Note: When the unit is plugged into a power source the Mode button will be green
whether or not the unit is ON or OFF. To determine whether or not the unit is on, press
the FEED button. If the printer feeds paper, unit is ON, if not, the unit is OFF.
To Next Page
Loading...