36
3. Go to the UTILITY MENU item 2
Upload Graphic Data on the Digimet.
4. Press Enter on the Digimet.
5. Choose your Graph to upload on the
Digimet.
6. Press Enter on the Digimet, one time.
7. Press the Upload Graph button on the
Digidata computer screen, the button
will change to “Press Digi then Here”.
8. Press Enter on the Digimet one more
time.
9. Press the “Press Digi then Here”
button. Button changes to
“******Uploading.” As uploading is
taking place this button will change to
“*****Still Uploading”. When uploading
is completed the button will say “*Done
Uploading”. The Save Graphic file
window will then appear. Choose a
name for your graph file and be sure it
ends with .dgr.
10. Press the OK button in the Save
Graphic files window.
11. Your graphic file has been uploaded
from the Digimet and saved as a
computer file.
Display Graph
Use the Display Graph command on the
computer screen to display a saved graph.
You will be asked for the file name. All
graph files for display are saved as .dgr
files. After choosing the file name the
graph will appear on the screen. While a
graph is being displayed the Display
Command button changes caption to
Close Graph and is in red. Choose Close
Graph to close. If Graph Settings (see
below) have been changed re-display
the graph using the Regraph button
which is located next to the Close
Graph button.
While a graph is being displayed, the
Menu item Graph Settings at the top of
the screen is enabled. By clicking on this
item, four graph variables can be set. 1)
Maximum vacuum level 2) Minimum
vacuum level 3) Start time for the graph
and 4) Finish time for the graph. The
reason for Start and Finish times is
because the Digimet can store up to a 10
second graph but you don’t have to view
the whole graph on the computer screen.
You can look at just a portion of the graph
by setting Start and Finish times. To
remove the graph variables from the
display click on Graph Settings again.
Send to D. Printer
Not Used
Rec. archive data
Not Used
Graph data
When a graph is being displayed on the
computer screen, pertinent data regarding
the graph appears in a window in the lower
right area of the computer screen. This
data also prints out with the graph when
printed.
Saving Files
This section will explain what different
computer files are saved when using the
software for the Digimet 3000.
.dm3 files - These files can be viewed in
the Windows program DigiData.exe. They
are the numeric data files.
.dgr files - These files would be graphic
data files that are uploaded to the
To Next Page
Loading...