Digistar TMR3610 - Rotation Counter; Drive Ratio

D4023-EN TMR3610 Operators Manual 25
11.7 Rotation Counter
The rotational counter is used much like the timer. It allows the indicator to count the number
of revolutions of a mixer shaft and notifies the operator when a set count is reached.
Note: First enter D.A.N. 4301, Press . Choose TIMER or COUNTER, by pressing .
Then press .
11.8 Drive Ratio
Drive ratio value is: number of turns seen by the sensor divided by the number of Mixer
rotations.
1. Press .
2. Use the numeric keypad to enter the
number of rotations.
3. Press .
4. The Rotation Counter will begin to
count down. When the counter
reaches zero the alarm light and
buzzer will turn on.
5. Press to enter the weighing mode.
6. Press the or key to re-enter
the batching mode.
1
4
3
2
5
6
1. Enter D.A.N. 4302
2. Press to enter the drive ratio
value. .
3. Press .
1
2
Advance Commands
3
6