DigiTech RP-7 VALVE - Section 2 - Setting Up; Making Connections; Connecting to Combo Amplifiers

Section-2 Setting Up
Making Connections
Your RP-7 Valve can be connected in several different ways to meet the requirements of specific applications. The following diagrams offer
some different ways your RP-7 Valve can be connected.
RP-7 Valve into two 2X12 Combo Amplifiers
For those of you out there that feel that “bigger is better”, this set-up should work quite nicely for you. First plug into the input of the RP-7
Valve. Connect both RP-7 Valve outputs into the inputs of both of the amplifiers. Using a set-up such as this will let you produce guitar tones
with lots of body. This is also a great set-up to produce lush and thick stereo effects.
Input
PARAMETER
SELECT
VALUE
EditStore
DISTORTION MOD/PITCH DELAY REVERB
BYPASSTUNER
COMPRESSOR
On/Bypass
Amount
On/Bypass
Type
Gain
On Level
Bypass Level
On/Bypass
Type
On/Bypass
Position (EP1)
Type
On/Bypass
Type Type
Level (EP4)
Amount (EP5)
Key (EP6)
Whammy (EP7)
On/Bypass
Level (EP8)
Time 1
Time 2
Fback (EP9)
On/Bypass
Type
Level (EP10)
Decay
PREAMP
SPEAKER CAB
WAH MOD/PITCH DUAL DELAY REVERB
On/Bypass
Low Gain
Mid Freq
Mid Gain
High Freq
High Gain
EQUALIZER
On/Bypass
Threshold
Attack Time
GATE/SWELL
Speed (EP2)
Depth (EP3)
Dly/Regen
VOLUME
Pre/Post
IN TUNE
EXP PEDAL
Link (EP # )
Max Value
Min Value
BANK PGM #
STORE
SIGNAL
CLIP
Level (EP11)
8888
Section -2 Setting Up
RP-7 Valve
User Guide
6