SECTION 4 - EFFECTS AND PARAMETERS
About the Parameter Matrix
The Parameter Matrix displays all the Effects and Parameters you can find in the RP-7 Valve. The Parameters are arranged in rows and columns.
Use the Parameter Select keys to navigate the matrix. The Effects and their Parameters are as follows:
The RP-7 Valve’s Compression can be used to increase sustain and to tighten up guitars, and is particularly useful on clean sounds.
Parameters of the RP-7 Valve compressor are as follows:
On / Bypass Turns the Compressor on or off.
Amount Controls the amount of compression applied to the signal. Higher settings yield a tighter, more focused
sound, while lower settings allow better dynamics. Ranges from 1-Lo to 78-Hi.
The RP-7 Valve’s Expression Pedal allows you to control various Parameters in real time during performance.
Link (EP) There are eleven Parameters that can be controlled by the Expression Pedal. These Parameters are
highlighted and labeled with parenthesis in the Parameter Matrix, indicating which EP link controls that
Parameter.
Max Value Sets the maximum value that the parameter assigned to the Expression Pedal will reach when the Pedal is
in the forward position. Range varies according to the parameter selected.
Min Value Sets the minimum value that the parameter assigned to the Expression Pedal will reach when the Pedal is
in the back position. Range varies according to the parameter selected.
Expression Pedal
Parameters
Displayed Values
Link (EP) OFF ... EP1 ... EP11
Max Value Parameter dependent
Min Value Parameter dependent
To Next Page
Loading...
Need help?
General
