Section 5 - Appendix
Reinitializing the RP-7 Valve
This option allows you to restore the contents of the RP-7 Valve’s memory to the original factory condition and calibrate the expression pedal.
WARNING: Performing this function will destroy all user-programmed data. All such data will be lost forever!
To restore the factory Programs and calibrate the expression pedal, the procedure is as follows:
1. Plug in the RP-7 Valve while holding down the Parameter Select <UP> button.
2. When rSt appears in the display window, press the Value <UP> button. The Rp-7 will reset to factory condition.
3. The display will now prompt you to re-calibrate the expression pedal by reading: PEDl CAL
4. When the display reads: toe dn , rock the pedal forward and press any one of the flashing footswitches.
5. When the display reads: toe up , rock the pedal back and press any one of the flashing footswitches. The expression pedal will now
be calibrated and the RP-7 will return to program mode.
Re-calibrating the Expression Pedal
If the Expression Pedal calibration should fail, you can re-calibrate it by disconnecting the power, press and hold the parameter select
<Down> button and re-apply power. Release the button and repeat steps 3-5 as shown in the “Re-initializing the RP-7 “ section above.
Harmony Interval Charts