The distortion section of the RP-7 Valve has six extremely flexible distortion types, capable of producing the smoothest of the blues tones to
the full shred gain of a cranked up stack.
On / Bypass Turns the Preamp on or off.
Type Selects the type of preamp voicing used. CLN1 is a warm clean tube tone, CLN2 is a bright clean tube
tone, BLUE is a bluesy distortion with moderate gain, SAT is a high gain tube distortion which is ideal
for soloing. On the solid state side, odr is a low to medium gain distortion, and Gru is an over the top
high gain distortion, HStn is a warm sustaining distortion, and FuZZ is a vintage full-frequency fuzz.
Gain Controls the amount of distortion produced by the RP-7 Valve. High settings produce greater gain and
drive for effortless soloing, while low settings offer better nuance and dynamic control. Ranges from 1 to
11.0.
Note: The Gain control parameter is not available in CLN 1 and CLN 2 preamp types.
On Level Sets the output level of the Distortion while the effect is ON. Ranges from -∞ to 12.
Off Level Sets the output level of the Distortion while the effect is OFF. Ranges from -∞ to 12.
To Next Page
Loading...
