27
Intensity - Knob 4 adjusts the intensity of the YaYa effect. Ranges from 0 to 99.
Range - Knob 5 adjusts the throaty quality of the YaYa effect. Ranges from 0 to 49.
SynthTalk
TM
(synthtlk)
SynthTalk
TM
is another effect exclusive to DigiTech
®
. It makes your guitar appear to speak based
upon the dynamics of your playing style.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Release - Knob 4 adjusts the release of the synthesized voice. Ranges 0 to 99, and oo
(infinity).
Vox - Knob 5 changes the characteristics of the various synth voices. Ranges from 0 to 99.
Sensitivity - Knob 6 adjusts the sensitivity of the input signal required to trigger the
SynthTalk effect. Ranges from 0 to 99.
Balance (X-Edit
TM
only) - adjusts the left to right balance of the wet signal, Ranges from
left 99 to right 99.
Step Filter (stepfltr)
The DigiTech Step Filter is like an automatic “random wah” with a square waveform.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Speed - Knob 3 adjusts the speed of the Wah effect. Ranges from 0 to 99.
Intensity - Knob 4 controls the intensity of the Wah effect. Ranges from 0 to 99.
Sample Hold (smplhold)
The DigiTech Sample Hold randomly shifts the pitch of the note you’re playing, creating an “elec-
tronic” or “robotic” sound.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Speed - Knob 3 adjusts the speed of the Sample Hold effect. Ranges from 0 to 99.
Intensity - Knob 4 controls the intensity of the Sample Hold effect. Ranges from 0 to
99.
DigiTech Whammy
®
(wHammy)
The DigiTech Whammy
®
is an effect that uses an Expression Pedal to bend the pitch of the
incoming signal, or add a bendable harmony with the original signal. As the Pedal is moved, the
note bends either up or down. When DigiTech Whammy is selected, it is automatically placed
before the internal amplifiers as shown in the block diagram on page 17.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Shift Amount - Knob 3 selects the interval and direction of the pitch bend. Choices are
as follows:
To Next Page
Loading...
Need help?
General
