28
Whammy
TM
(no Dry Signal)
1 oct up (1 octave above)
2 oct up (2 octaves above)
2nd down (a second below)
rev 2nd (a second below reversed pedal action)
4th down (a fourth below)
1 oct dn (an octave below)
2 oct dn (2 octaves below)
DIVeBoMb (Dive Bomb)
Harmony Bends (Dry Signal Added)
mn3>Maj3 (a minor third to a Major third)
2nd>maj3 (a second above to a Major third
above)
3rd->4th (a third above to a fourth above)
4th->5th (a fourth above to a fifth above)
5thoctup (a fifth above to an octave above)
h oct up (one octave above)
h oct dn (one octave down)
octup>dn (octave up/down)
Pedal Position - Knob 5 provides a manual control of the Whammy pedal position.
Ranges from 0 to 99.
Mix - Knob 6 adjusts the Whammy mix. Ranges from 0 to 99.
Pitch Shift (PitCH)
A Pitch Shifter copies the incoming signal, then shifts the pitch of the copy to a different note.
The shifted note is then mixed back with the original signal, sounding as if two guitars were play-
ing different notes.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Shift Amount - Knob 3 selects the interval of the shifted pitch. Ranges from -24 (2
octaves below) to 24 (2 octaves above).
Mix - Knob 6 controls the mix level of the shifted pitch. Ranges from 0 to 99.
Detune (DetUNe)
A Detuner makes a copy of your incoming signal, takes the copied signal slightly out of tune from
the original, then mixes the two signals together. The result is a doubling type of effect as if two
guitars were playing the same part together.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Shift Amount - Knob 3 adjusts the amount of detune shift. Ranges from -24 to 24
cents.
Level - Knob 6 controls the mix of the detuned note. Ranges from 0 to 99.
Harmony Pitch Shifting (harmony)
Harmony Pitch Shifting makes a copy of the incoming signal, and then changes the pitch of the
copied note to a diatonically correct interval specified by the Amount parameter. A Harmony
Pitch Shifter sharpens or flattens the shifted pitch in order to keep the specified interval within
the selected key and scale creating a true harmony.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Shift Amount - Knob 3 selects the amount or harmony interval for the Harmony Pitch
Shifter. Interval choices include:
To Next Page
Loading...
