Dimplex A12M - Default Chapter; Table of Contents

iii
Contents
1 Introduction .......................................................................................... 1
2 Scope of delivery ................................................................................... 1
3 Pre-Installation advice .......................................................................... 5
3.1 Warnings .......................................................................................... 5
3.2 Intended use ..................................................................................... 6
3.3 Legal ................................................................................................ 6
3.4 Heat pump sizing ............................................................................... 6
3.5 Site selection ..................................................................................... 6
3.5.1 Location of heat pump ................................................................... 6
3.5.2 Heat pump placement and fixing ..................................................... 7
3.6 Plumbing –Preparation ........................................................................ 8
3.6.1 Buffer tank ................................................................................... 9
3.7 Electrical connections - Preparation ...................................................... 9
4 Installation .......................................................................................... 10
4.1 Handling and transport ..................................................................... 10
4.2 Plumbing......................................................................................... 10
4.3 Electrical connections ....................................................................... 11
4.4 Opening the heat pump for electrical connections ................................. 15
4.4.1 Heat pump electrical connection .................................................... 16
5 Set to work .......................................................................................... 17
5.1 Location of indoor components .......................................................... 17
5.2 Set to work ..................................................................................... 17
5.3 Opening the UI ................................................................................ 17
5.4 Using the User Interface ................................................................... 18
6 Pre-commissioning .............................................................................. 18
6.1.1 General/Schematic ...................................................................... 19
6.1.2 Message log ............................................................................... 19
6.1.3 Output Tests .............................................................................. 19
6.1.4 Defrost ...................................................................................... 19
6.1.5 Operating data ........................................................................... 19
6.1.6 History ...................................................................................... 19