The heater controls can be easily adjusted by using the six buttons on the User Interface.
1
The Display Screen shows the options available at each stage of adjustment.
2
Menu - displays the main options list;
- Date/Time - Set the date and time.
- Mode - Set the mode of operation.
- Options - Keypad sound, daylight savings time, communication settings and service
information.
3
Back returns to the previous programming stage.
4
The UP and DOWN buttons are used to navigate through the menus and alter
setting values. The UP and DOWN buttons are also used to adjust the required
room temperature on the main screen. The screen colour changes based on the
temperature selected, showing deep blue through to bright red.
5
Enter is used within the menu options to confirm settings. On the main screen
pressing Enter will display the enabled features.
The timed periods during which the heater is providing heat are defined as ‘Comfort
On’ (this is displayed at the bottom of the screen).
Outside of heating periods the heater will not deliver heat and these periods are
called ‘Comfort O’.
While constant heat modes are active, the mode of operation is displayed at the
bottom of the screen e.g. ‘Out All Day’.
6
The Advance button overrides the heating settings and changes the operational
state of the heater. Pressing Advance will cause the heater to remain on until the
next Comfort O period is due, or o until the next Comfort On period is due.
Control Functions
17
To Next Page
Loading...
Need help?
General
