DWG2000 GSM/CDMA/WCDMA User
Manual
be displayed.
Step 2. Click the Add button to configure IP Trunk.
You can choose any one from 0 – 31, but indexes of different IP trunk cannot
be the same.
The IP address of the device (for example: DAG) connected to the DWG2000.
The port of the device (for example: DAG), through which the DWG2000 is
connected to the device.
You can enter any description you want.
If KeepAlive is enabled, the DWG2000 will examine whether the IP trunk is
available or not.
Step 3. Click OK on the interface.
Step 4. If you need to delete or modify the IP trunk, click the on the left of the IP Trunk, and then click
Delete or Modify.
4.14.2 Configuration of IP Trunk Group
Step 1. In the navigation tree of Web Management System, click IP Trunk Configuration IP Trunk
Group, and the following interface will be displayed.
To Next Page
Loading...
